being i was a ford fanatic most my life im not sure about the cheby wheel pattern that works on trackers

is it a 5x5.5

Trackers/Sidekicks/Samurais do have a 5 on 5.5" bolt pattern.

I thought Chevys bolt pattern (FS trucks, FS blazers) was 5 on 5" (or at least the more common one was).  Maybe they used a 5 on 5.5" pattern at some point....I'm not sure.

The early Ford trucks (early bronco, FS bronco, F150) up 'til 98 or so, use the 5 on 5.5" pattern.

The early ('til 80 something, I think) CJ Heeps also use the 5 on 5.5" bolt pattern.

Not sure if that really answers your question.

One thing you need to check, if you are swapping wheels from one make to another.......make sure the hole in the center of the wheel is big enough to clear the hubs on the front axle and drum mounting bolts/nuts on the rear axle......some are, some aren't.....this applies to both factory and aftermarket wheels.  The center hole needs to be something like 4 1/8", IIRC.

thanks bud

good enough




nunk,  ill go ahead and get them,  if they wont work

 they will on a sami, and i need some moving around tires

added a little more info, to my post above.....

are sammi and tracker wheels interchangable? i know they are the same lug pattern but are their hubs the same and center hole the same?

I've seen Sammis with Tracker wheels and vice versa

Yes.  The hubs are the same diameter, and will actually interchange (for the samurai hubs to fit a trackick, 2 gaskets usually have to be used between the hub body and wheel hub, IIRC).

also, yes some heeps have the same 5 x 5.5 pattern, but, i have steel spokes from a heep and the center hole is/was to small.  also the wheel spacers from spidertrax that i had on my 90 would not fit on my 04 because the center hole was 1/16" to small.  just some additional info.....