I am looking for some parts for a tracker or Sidekick. I have a 95 8V I am looking to make into a hunting rig but I need some dash parts. I also have a bent rear end tire wobbles quit a bit but drives OK. let me know if anyone out there has some parts I might be able to buy or if anyone knows where one can be found for parts.

Welcome to KCZuks.com   A few of out members always seem to be parting out a Tracker or a Sidekick.  You might be more specific about what you need.

I have a selection of trackick parts....what are you needing specifically?  95, 8V huh?......must have been 2wd at some point (or still is).

what I have is a previous 16V tracker 4x4 now an 8V yeah owner before me blew the motor and swapped in a 8V that he had. I need dash w/center have guage cluster dash is little tore up. I could use a rear end too mine seems to have a bent axle or something it wobbles but doesn't effect the ride. I am sure there are a few other things I will need in the future just getting started on this. thanks Marc

Ahhh, or had an engine swap done on it.  How hacked is the wiring?  A 16V to 8V swap would require quite a bit of the wiring to be swapped.

Have you checked to make sure it isn't just a bent rear wheel?  Otherwise, it is probably just a bent axle shaft and you might be able to get by just replacing the shaft.  Which side is bent?  I have an axle shaft here, but I don't remember what side it is.
On the dash parts, I still don't know what you need for sure......a complete dash, except for the instrument cluster?

it is the passenger side rear axle as for the dash it has been hacked up pretty good in the center and the glove box just falls out. I have mitchell on demand so I can fix the wires it wasn't a bad job looks like he actually pulled the harness from the 8V so not to bad. I am new to these but I hear if you don't swap the fuel pump then they will burn rich? tell me what you think I am getting a header and going to build this one a little. thanks for you input. Marc

The fuel pumps are the same between the 8V and 16V, so it will not run rich.

Let me check on that rear axle shaft and get back to you.

So you are wanting a complete dash assembly then?

yes to the dash

Anything on that Dash? how bout that rear axle shaft? let me know Thanks Marc

The dashes I have available aren't the same style as the one you have.  These both have the flat place above the glove box (89-90 style).  They should fit yours, they just won't be like your old one.
The rear axle shaft I thought was straight, isn't.  Or at least it didn't run exactly true when I spun it in the lathe.  But I do have a complete rear axle I could pull the shafts out of, or just the passengers side, I guess.
Let me know if you are interested in anything, or have any questions........I can send you pics and/or prices.

is there an alternative to the rear axles for these trucks? would you consider maybe selling me the whole rear end. what do the dashes look like any chance I could get a pic? what is a safe height for suspension lifts for these? I would like to lift mine and run some decent mud tires. Thanks Marc

I could sell the whole rear end.
Let me get some pics of the dash.
I'll either PM or email you the pics and info.